Contour Gauges have many, non-marring plastic fingers that move to follow intricate contours, curves or profiles. This quickly creates an exact model from finished or unfinished workpieces without scratching. They work great for lathe or bandsaw work where you need to duplicate a part or transfer contours for fitting panels, moldings or lay out around fixtures:

Simply press gauge against contour and the 1/16"x 4" moving, plastic fingers transfer the matching shape to the top side of the gauge. Then just mark and cut for an exact matching fit.

Fingers will handle shapes to 1-1/4" deep.

Shape of the finger ends allows tremendous versatility when getting into tight spots.

Gauges have graduations on both sides to make transferring tricky shapes easier.

Small Gauges Models "A" or "B" handle lengths up to 5" each.

Large Gauge "A" works for lengths up to 10".

Gauge "B" is similar to "A" but is made to connect end-to-end with Gauges "A" for additional length.

Imported.